Click image to view full size image
Deep Groove Ball Bearing 6011 repair and installation matters after car tires burst
First of all, we need to hook the rotten bearing seals and balls inside of Deep Groove Ball Bearing 6011 with circlip pliers, and then clean them.
Next, the bearing outer tool puller is used to pull out the bearing outer diameter.
Secondly, we are installing new bearings. When installing, we must pay attention to the size of the steel pipe opening of the installation tool. The diameter of the bearing must be the same as the diameter of the bearing. During the installation process, the inner diameter must be beaten. It is noted that when we are installing new bearings, do not touch the butter, because the butter of the manufacturer's crude oil is the best. Beat the bearing again. So even if the bearing is mounted on the upper shaft.
Once again, we will butter the axle shaft and install it on the wheel. Here, we will hit the outer circle of the bearing and knock it in. Then install the spring, and use the spring pliers to snap in the spring. The spring on the bearing and the bearing must be installed tightly.
http://www.frfbearing.com/